Apex Destiny 6100 Basic Commands
| Zones | 6100 - 16 Hardwired, up to 80 total with wireless 4100 - 8 Hardwired, up to 40 total with wireless | ||
| Batteries |
| ||
| Wireless | Yes | ||
| Downloadable | Yes - Via Compass | ||
| Panic Buttons |
| ||
| Status | Press STATUS, keypad will speak current status or open zones | ||
| Arm Away | Press A or User Code + A (Keypad says "Armed to Away") | ||
| Arm Stay | Press H or User Code + H (Keypad says "Armed to Home") | ||
| Force Arming | (with zone open) Press A (Keypad says "Force Armed to Home") | ||
| Instant Arm | Press H twice within 10 seconds (Keypad says "Armed to Night") | ||
| Disarm | 4-digit code (Keypad will say "Control is Disarmed") | ||
| Reset Alarm | 4-digit code | ||
| Bypass | 1. Enter 4-digit code 2. Press 9 (Keypad will say "BYPASS MODE, Enter Zone #) 3. Enter Zone (01 to 80) (keypad will say current bypass state of zone) 4. Press A to enable bypass 5. Press H to end (Clear all bypasses enter 00 while in BYPASS mode | ||
| Speak Time | 4-digit code + 1 | ||
| Change Time | Press 2 & 8 keys at same time, enter 4 digit time + 1 for AM or 2 for PM | ||
| Door Chime | Press MONITOR once for Tone, again for talking chime, again to turn off | ||
| F1 Key | Turns Home Automation devices (such as lights) On or Off 1. Press F1, system will speak devices to activate ("1 for Bedroom Lights" etc) 2. Press number of device (for example 01) then A to turn On, H to turn Off 3. Press F1 again to exit | ||
| F2 key | May be programmed to speak Time and Date | ||
| Reset Smoke | 4-digit code + 6 (Keypad will say "Smoke Power") | ||
| Phone Test | 4-digit code + 0 | ||
| Light Control | (If available) Press 8888 or F1/F2 | ||
| Door Chime | Enter 4-digit code + 2 | ||
| Display Adjust | Press 4 and 7 to raise or lower keypad lights | ||
| Remote Access | All below can be done from phone, the * key is A, # key is H At Home 1. Pick up phone and enter Local Phone Access Code (different from User Code, customer should know this code) 2. Telephone will now act like keypad and use same commands 3. To finish either hang up phone or do nothing for 15 seconds | ||
| While Away | 1. Call home # and let ring for a programmed time (programmed by installer) 2. When system picks up enter disarm code within 5 seconds 3. Telephone will now act like keypad and use same commands 4. To finish either hang up phone or do nothing for 15 seconds | ||
| 2-Way Access | (By Customer) 1. Access system with above steps 2. Press 9999 to activate "Listen Mode" 3. Press # to talk, * to listen 4. To end either hang up phone or press 0 |
